The recommendation for the base liquid 80/20 is to use a mix of 80% vegetable glycerin (VG) and 20% propylene glycol (PG). This ratio is commonly used in e-liquids to provide a balance of vapor production and flavor. The higher VG content will result in thicker clouds of vapor, while the PG helps carry the flavor and provides a stronger throat hit. It's important to note that individual preferences may vary, so it's always a good idea to experiment with different ratios to find the perfect balance for your vaping experience. **

The best home base depends on personal preferences and needs. Some may prefer a home base that is close to family and friends, while others may prioritize a home base with good job opportunities or a low cost of living. Ultimately, the best home base is one that aligns with an individual's lifestyle, goals, and priorities. **

No, it is not recommended to mix a 65/35 base with a 50/50 base. These bases have different ratios of propylene glycol (PG) and vegetable glycerin (VG), which can affect the overall consistency and performance of the e-liquid. Mixing these bases can result in an unbalanced blend that may not vaporize properly or provide a satisfying vaping experience. It is best to stick to using the same type of base when mixing e-liquids. **

To convert a number from base 3 to base 10, you need to multiply each digit of the base 3 number by 3 raised to the power of its position from right to left, starting from 0. Then, sum up all these products to get the equivalent base 10 number. For example, to convert the base 3 number 201 to base 10, you would calculate 2 x 3^2 + 0 x 3^1 + 1 x 3^0 = 18 + 0 + 1 = 19. **

There is no such thing as an unraidable base in Rust. While players may create bases that are difficult to raid due to their design or location, no base is completely impervious to attack. The concept of an "Iceberg Base" may refer to a base built on an iceberg, which could potentially be difficult to raid due to its remote location and limited access points, but it is not unraidable. In Rust, the goal is to constantly improve and fortify your base to make it as difficult as possible for other players to raid, but no base is immune to attack. **

To remove the base coat, you can use a nail polish remover that is specifically designed to remove gel or regular nail polish. Soak a cotton ball or pad with the nail polish remover and then hold it against the base coat for a few seconds to allow the remover to penetrate the polish. Gently rub the cotton ball or pad over the base coat until it starts to lift and dissolve. You may need to repeat this process a few times to completely remove the base coat. If you are using a gel base coat, you may need to use a gel polish remover and follow the specific instructions for gel polish removal. **

Yes, a weak base can react with an even weaker base. In a reaction between two bases, the stronger base will donate its hydroxide ion to the weaker base, resulting in the formation of a new compound. The strength of a base is determined by its ability to accept a proton, so even a weak base can react with an even weaker base if the conditions are right. This reaction may result in the formation of a new compound with different properties than the original bases. **

To convert a number from base 2 to base 10, you can use the positional notation system. Start by writing down the binary number and assigning each digit a position value, starting from 0 on the right. Then, multiply each digit by 2 raised to the power of its position value and add up the results to get the decimal equivalent. For example, to convert the binary number 1010 to decimal, you would calculate (1*2^3) + (0*2^2) + (1*2^1) + (0*2^0) = 8 + 0 + 2 + 0 = 10. **